Aem 30-2500 AQ-1 Data Logging System Manuel d'utilisateur télécharger pdf (Page 4)

Page 4 10-2500 AQ1 Instructions RevD 102512.doc

Plug the Deutsch 4-pin DTM connector on the AQ1 Data Logger harness into the

mating connector on other AEMnet compatible devices. See “Using the AQ1 Data

Logger” for more information on configuring the AEMnet.

INPUT SIGNALS

Analog 1-4 are 0-5V analog inputs with optional pull-up resistor for RTD/Thermistor-

style sensor. Examples: AEM gauges, MAP/pressure sensors, TPS/APP/shock

travel/load cell sensors, analog MAF sensors, any 2 wire RTD or thermistor style temp

sensor. See “Using the AQ1 Data Logger” for more information on configuring Inputs 1-

4. The corresponding wires in the harness for Analog 1-4 are Yellow and are labeled

INPUT 1, INPUT 2, INPUT 3 and, INPUT 4.

Analog/Frequency 5-8 are analog inputs for that can optionally measure frequency (0-

5 V or 0-16 V) Examples: RPM, vehicle speed, frequency based MAF, injector duty

cycle, boost control solenoid, flow sensor, hall sensor, any 3 wire pressure sensor. See

“Using the AQ1 Data Logger” for more information on configuring Inputs 5-8. The

corresponding wires in the harness for Analog/Frequency 5-8 are Yellow and are

labeled INPUT 5, INPUT 6, INPUT 7, and INPUT 8.

Connection diagrams are shown below for some of the more common sensors/signals

to be used with Inputs 1-4 and Inputs 5-8. See Figure 2.

Figure 2. AEM Pressure Sensors(Left) AEM Temp Sensor (Right)

1 2 3 4 5 6 7 8 9 ... 21 22

Pas de commentaire

Aem 30-2500 AQ-1 Data Logging System Manuel d'utilisateur Page 4